Description
The 6″ AIR-LOK Series M-LOK Compression Free Floating Handguard is a lightweight, high-rigidity component designed for builders who need a monolithic top rail appearance without the excessive weight of a full milled system. Constructed from T6 aluminium extrusion, this handguard features a hexagonal outer profile with triangle and diamond skeletonized cuts that remove material from non-load-bearing areas while maintaining structural rigidity around the barrel nut compression zone. The Anodized Royal Purple finish is Type III hardcoat, applied after machining to preserve dimensional tolerances and provide abrasion resistance. Total installed weight is 6.2 oz including the proprietary barrel nut, making it one of the lightest full-length rigid handguards compatible with both 5.56 calibre and 9mm calibre upper receivers.
The AIR-LOK compression system replaces conventional clamp designs with a sliding barrel nut interface. The handguard slides over the included barrel nut, then four set screws compress it down against the receiver face. This produces a tight fit with no visible gap between handguard and upper receiver, allowing the monolithic Picatinny top rail to run uninterrupted from the receiver rail. The internal diameter is 1.32 inches, clearing most barrels and low-profile gas blocks without interference. M-LOK slots run along three sides — bottom, left, and right — providing modular attachment points for accessories while keeping the top rail continuous. The hexagonal profile indexes the handguard during installation and increases resistance to rotation under side loads. Six inches in length, this handguard is sized for pistol-length gas systems and short-barrelled builds where a compact rail section is required ahead of the receiver. All components, including the proprietary barrel nut and compression screws, are manufactured in the United States.






Reviews
There are no reviews yet.